Under the television

6-Foot Non-Polarized C7 TV Cord Kit for Inverted Outlets

A thin plate for upside down outlets that replaces your television power cord with a figure eight plug and adds three outlets below.

$21.95as listed when built

Check it against your wall

When an outlet is installed with the round ground hole over the flat slots, standard plates sit upside down. We molded this plate specifically for those reversed receptacles behind a television. It plugs into the upper socket, drops flat against the drywall, and brings power to your set without thick plugs in the way.

Where it runs: Under the television
Ground pin: Ground pin up
Cord length: 6 ft
Sockets on the strip: 3
Far end: C7 appliance plug
Wall box: Single gang
Rated for: 125 volts

Inverted outlet fit

Check your wall before choosing this piece. It fits duplex receptacles installed upside down, where the round pin hole sits above the two vertical prongs. The molded face covers both sockets completely.

Figure eight television end

This cord replaces the original power lead of your television. The far end has two rounded lobes side by side with identical flat prongs, fitting most flat screens, sound bars, and streaming boxes either way round.

Power strip at base

The flat cord travels down toward the baseboard and ends in three regular receptacles. You get extra spots for media players, game consoles, or a table lamp right where the gear sits.

Removable adhesive clips

The kit includes removable adhesive strips and clips to guide the flat cord down the painted surface. Clean the drywall with rubbing alcohol first so the tape bonds well without pulling paint later.

$21.956-Foot Non-Polarized C7 TV Cord Kit for Inverted Outlets

Cut the same way