Under the television

6-Foot C7 TV Cord Kit for Inverted Outlets

A thin replacement cord and cover plate for inverted wall outlets, made so a television can sit back against the drywall instead of on a plug.

$20.95as listed when built

Check it against your wall

Many homes have duplex outlets installed upside down, with the round ground hole over the two vertical slots. We mold this plate to match that orientation. It plugs into the top receptacle, covers the whole outlet face, and runs a flat cord straight up to the television input.

Where it runs: Under the television
Ground pin: Ground pin up
Cord length: 6 ft
Far end: C7 appliance plug
Wall box: Single gang
Rated for: 125 volts

For inverted wall sockets

Check the outlet before choosing this one. The round hole must sit at the top. This plate aligns with that layout so the cord exits downward without binding against the wall plate or trim.

Replaces the factory lead

The far end has the common figure eight connector with two rounded lobes. It plugs directly into the back of the screen or media box, replacing the thick cable that came in the box.

Flush against the wall

Because the plate stays flat, the display can push back all the way on its mount. A media console or shelf underneath can also sit against the baseboard without leaving an intentional gap for plugs.

Removable wall clips

The kit includes double-sided adhesive strips and small clips. Clean the painted drywall with rubbing alcohol first, press the strips in place along your planned run, and route the flat white cord straight.

$20.956-Foot C7 TV Cord Kit for Inverted Outlets

Cut the same way