Under the television

5-Foot C13 TV Cord Kit for Inverted Outlets

A thin replacement power cord for televisions mounted over inverted wall outlets, leaving extra outlets on a small strip near the floor.

$22.95at our retail partner

5.0 1 rating

Check it against your wall

A wall mounted television often stops an inch out from the drywall because its thick power cord collides with the receptacle behind it. We mold this thin cover to fit duplex outlets where the ground hole sits at the top. It replaces the television cord and drops down the baseboard to a three outlet strip.

Where it runs: Under the television
Ground pin: Ground pin up
Cord length: 5 ft
Sockets on the strip: 3
Far end: C13 appliance plug
Wall box: Single gang
Rated for: 125 volts

For inverted wall receptacles

Look at the wall behind the television before ordering. This version fits outlets hung with the round ground opening above the two parallel slots, which is common in remodeled living rooms.

Replaces the television cord

The line coming off this plate runs up to the back of the television and ends in a squarish three hole connector. It takes the place of the factory cord completely.

Power strip at the bottom

The lower drop gives you three standard outlets near the floor. Media boxes, soundbars, and game consoles plug in down low where the shelf sits, instead of behind the screen.

Removable wall clips

Double sided adhesive strips and small plastic clips come in the box to hold the flat line down the wall. Press them against clean paint to keep the run straight.

$22.955-Foot C13 TV Cord Kit for Inverted Outlets

Cut the same way