Under the television

6-Foot Non-Polarized C7 TV Cord Kit

Swap your television power cord for a flat plate that lets the set sit against the wall, with extra outlets at the end of the run.

$21.95as listed when built

Check it against your wall

A wall mount or a low media stand brings the back of the set close to the wall. An ordinary plug sticks out too far to let it rest there. We molded this plate to sit flat over the whole outlet face, with a dedicated figure eight cable for the television and a small strip for the rest of your gear.

Where it runs: Under the television
Ground pin: Ground pin down
Cord length: 6 ft
Sockets on the strip: 3
Far end: C7 appliance plug
Wall box: Single gang
Rated for: 125 volts

Standard outlet orientation

This plate fits a standard duplex outlet where the round ground pin hole sits beneath the two vertical slots. It pushes directly into the upper socket, covering the entire wall box without requiring you to remove any screws.

Figure eight television lead

The dedicated television cable ends in two rounded lobes that push directly into the back of the set. The plug is non polarized, so it fits either way into most screens, streaming boxes, and sound bars without adapters.

Extra plugs at the end

The flat cord travels six feet down the baseboard to a small power strip with three sockets. You get extra room to plug in a gaming console, streaming puck, or speaker right where those devices sit on the console shelf.

Removable adhesive mounting

We pack double sided strips and clips in the box to hold the flat cord along painted baseboards or drywall. The adhesive wants a clean surface, and it comes away cleanly when you rearrange the room.

$21.956-Foot Non-Polarized C7 TV Cord Kit

Cut the same way