Under the television

5-Foot Non-Polarized C7 TV Cord Kit

A thin wall plate and flat cord kit that replaces your television power lead and adds a three outlet strip below.

$21.95as listed when built

5.0 1 rating

When a television hangs on a mount or sits on a low console, the factory power cable often holds the screen away from the wall. We mold a thin cover plate that plugs directly into your existing top receptacle, dropping a flat cord down the wall to feed your screen and your other gear.

Where it runs: Under the television
Ground pin: Ground pin down
Cord length: 5 ft
Sockets on the strip: 3
Far end: C7 appliance plug
Wall box: Single gang
Rated for: 125 volts

Standard duplex orientation

This piece fits an outlet where the round ground opening sits beneath the two vertical slots. Plug our plate into the upper receptacle to cover the face of the outlet completely.

Figure eight television lead

The far end of our cord carries a symmetrical connector with two rounded lobes side by side. It fits the power inlet on most flat panels, media players, and sound bars without directional orientation.

Three extra outlets below

The run finishes at a small block with three receptacles ready for streaming sticks, consoles, or speakers. You gain more places to plug in gear than the wall plate covered up.

Removable wall clips

We put double sided adhesive strips and small cord clips in the box to guide the flat run along baseboards or paint. Press them onto dry, clean drywall to keep the line straight.

$21.955-Foot Non-Polarized C7 TV Cord Kit

Cut the same way