Under the television

6-Foot Angled C7 TV Cord Kit for Inverted Outlets

A thin plate for upside down outlets that replaces the television power cord, runs six feet along the wall, and ends in three extra receptacles.

$21.95as listed when built

Check it against your wall

When an outlet was installed with the round ground hole on top, regular concealers face the wrong way. We molded this plate for that inverted wall plug. It drops down flat, brings the cord along the baseboard, and puts the power strip down where the media boxes sit.

Where it runs: Under the television
Ground pin: Ground pin up
Cord length: 6 ft
Sockets on the strip: 3
Far end: C7 appliance plug
Wall box: Single gang
Rated for: 125 volts

Inverted outlet fit

Check your wall first. This plate only fits a duplex outlet hung with the round ground hole above the two vertical slots. It pushes directly into that top receptacle without removing the existing faceplate.

Television power end

The far end takes the place of the factory cord on your set. It uses the flat figure eight shape with twin rounded sides, angled so the television can sit back without bumping the plug.

Six foot wall run

The flat cord leaves the bottom of the plate and travels down the wall. We include removable adhesive strips and clips in the box to keep the line straight along the drywall without sagging.

Three outlets below

At the floor end, the line splits to feed the set and a small block with three receptacles. That gives you spots for a streaming box, a soundbar, and a game console right on the console shelf.

$21.956-Foot Angled C7 TV Cord Kit for Inverted Outlets

Cut the same way