Under the television

6-Foot Angled C7 TV Cord Kit

A thin plate that covers the wall outlet behind your television, paired with a replacement power cord and extra places to plug in media gear.

$21.95as listed when built

3.8 7 ratings

Check it against your wall

A wall mount loses its appeal when a thick plug holds the screen away from the drywall. We mold this flat plate to replace the original power cord on the television while giving you a small strip for streaming boxes. It sits flush against the wall so the frame can push back where it belongs.

Where it runs: Under the television
Ground pin: Ground pin down
Cord length: 6 ft
Sockets on the strip: 3
Far end: C7 appliance plug
Wall box: Single gang
Rated for: 125 volts

Matching standard outlets

Check that the round ground hole sits below the two vertical slots on your wall. The plate prongs push directly into the upper receptacle like an ordinary plug, with no faceplates removed and no screws turned.

Angled figure eight connector

The end that meets the back of the television has two rounded lobes side by side. We shaped the mold with an angle and unpolarized blades, so the cord turns flat against the casing rather than sticking straight out.

Down along the baseboard

A flat cord drops from the plate down to where your other gear sits. We put removable adhesive strips and clips in the box to hold the run straight against painted drywall or wood trim without sagging.

Three outlets below

The far end opens into a small strip with three receptacles for sound bars or media boxes. You gain places to plug in gear at shelf level instead of stretching cords up behind the frame.

$21.956-Foot Angled C7 TV Cord Kit

Cut the same way