Under the television

6-Foot Angled C13 TV Cord Kit for Inverted Outlets

A thin plate for inverted outlets that replaces the television power cord and runs a flat line down to three extra outlets behind your media stand.

$22.95as listed when built

Check it against your wall

When an outlet is installed upside down with the round hole on top, regular plates will not seat right. We molded this plate specifically for inverted wall receptacles. It plugs into the upper socket, covers the entire outlet face, and brings power directly to your screen while dropping a separate small strip below.

Where it runs: Under the television
Ground pin: Ground pin up
Cord length: 6 ft
Sockets on the strip: 3
Far end: C13 appliance plug
Wall box: Single gang
Rated for: 125 volts

For inverted wall sockets

Look at your wall before choosing this model. It fits duplex receptacles installed upside down, where the round ground opening sits above the two vertical slots. If your outlet faces that way, this plate drops right on without modification.

Replaces the television cable

The far end of our cord plugs directly into your set using the angled, squarish three hole connector found on larger screens. Because the connector turns sideways, the back of the panel can sit much closer to the wall.

Power strip included below

You do not lose places to plug things in. Along with the television connector, the line provides a block with three standard outlets at the base. You gain extra receptacles for your streaming box, sound bar, or gaming console.

Adhesive clips in box

The flat cord runs straight down your drywall inside adhesive clips and double sided strips that come in the package. They hold the line flat against the baseboard and remove cleanly later without pulling down paint or leaving residue.

$22.956-Foot Angled C13 TV Cord Kit for Inverted Outlets

Cut the same way