Under the television

6-Foot Angled C13 TV Cord Kit

A thin wall plate and replacement power cord for a television that needs to sit back flat, ending in a three outlet strip for the media stand below.

$22.95as listed when built

Check it against your wall

A television mount can only bring the screen as close to the wall as the thick factory plug behind it allows. We mold a thin plate that plugs into the upper receptacle and covers the outlet completely, routing power down a flat line. That line replaces the stock television cable and drops extra plugs below.

Where it runs: Under the television
Ground pin: Ground pin down
Cord length: 6 ft
Sockets on the strip: 3
Far end: C13 appliance plug
Wall box: Single gang
Rated for: 125 volts

Standard outlet orientation

This model fits an ordinary duplex wall receptacle where the round ground pin sits beneath the two vertical slots. The cover plugs straight into the top half like any household cord, without tools or loose hardware.

Angled three hole connector

The television end replaces the original power lead with an angled, squarish three hole plug. Because that connector turns immediately sideways, the back panel of the set can sit closer to the drywall.

Included adhesive channel clips

The flat cord travels straight down the baseboard or behind the mount using removable double sided adhesive strips and small clips from the box. They stick best to drywall that has been wiped clean of dust.

Extra plugs below

At the lower end of the run, the line splits into a small three outlet block. That puts power right behind the media console for a streaming box, a game console, or an audio receiver.

$22.956-Foot Angled C13 TV Cord Kit

Cut the same way