Under the television

5-Foot C13 TV Cord Kit for Standard Outlets

A thin wall plate and replacement power cord for a television on a stand, leaving room for the screen to sit back flat against the wall.

$21.41as listed when built

2.0 1 rating

Check it against your wall

A thick television plug holds the whole screen out from the wall. This kit replaces that factory cable with a thin plate that plugs into the top receptacle, then sends power up to the screen and down to a small strip for other gear.

Where it runs: Under the television
Ground pin: Ground pin down
Cord length: 5 ft
Sockets on the strip: 3
Far end: C13 appliance plug
Wall box: Single gang
Rated for: 125 volts

Standard duplex orientation

We mold this plate for standard wall receptacles where the round ground pin sits beneath the two vertical slots. It pushes directly into the upper plug without removing the original faceplate or loosening any screws.

Squarish three hole end

The power line runs straight to the back of the set, ending in the squarish three hole connector found on larger screens and desktop gear. It takes the place of the bulky factory cord entirely.

Extra outlets below

The drop line brings power down to a small block with three grounded outlets. That leaves room for a streaming box, a soundbar, or a game console sitting on the stand beneath the screen.

Removable wall clips

The cord runs along the baseboard or behind the stand using the double sided adhesive strips and clips in the box. Press them to clean drywall to hold the line flat.

$21.415-Foot C13 TV Cord Kit for Standard Outlets

Cut the same way