Under the television

5-Foot Angled C13 TV Cord Kit

A thin wall plate and replacement television cord with an angled three hole end and a floor strip for media gear, built for standard upright outlets.

$22.95as listed when built

5.0 1 rating

Check it against your wall

A wall mounted television often stops short of the drywall because thick power heads stick straight out behind it. This kit replaces the original cord on the set and covers the wall receptacle with one thin faceplate. The flat wire drops to baseboard height, feeding both the screen and a small three outlet block.

Where it runs: Under the television
Ground pin: Ground pin down
Cord length: 5 ft
Sockets on the strip: 3
Far end: C13 appliance plug
Wall box: Single gang
Rated for: 125 volts

Matching standard outlets

We molded this piece for standard duplex receptacles where the round ground opening sits beneath the vertical slots. The cover plugs straight into the upper socket, blanking off the face without needing a screwdriver or opening drywall.

Angled television plug

The cord end that meets the back of the set uses the squarish three hole shape common on larger screens. It turns at an angle so the wire sits flat against the chassis instead of pushing outward into the room.

Extra outlets below

A separate five foot branch drops down the baseboard to power the rest of the media shelf. The strip at the end provides three outlets, giving you spots for a streaming box or speaker console where the wall plate used to be.

Removable adhesive routing

Adhesive strips and clips come in the box to hold the flat cord down along painted drywall or wood trim. Pressing them firmly against a clean, dustless wall keeps the wire straight and lifts away cleanly whenever you rearrange.

$22.955-Foot Angled C13 TV Cord Kit

Cut the same way