Under the television

5-Foot Non-Polarized C7 TV Cord Kit for Inverted Outlets

Replace your television power cord at an inverted wall outlet so the set can sit flat, with a small strip left over for other gear.

$21.95as listed when built

Check it against your wall

When an outlet is mounted with the round ground hole on top, an ordinary plug pushes a mounted screen away from the wall. We mold this plate to drop straight onto that inverted receptacle. The thin cord replaces the television power line and runs to a small strip below.

Where it runs: Under the television
Ground pin: Ground pin up
Cord length: 5 ft
Sockets on the strip: 3
Far end: C7 appliance plug
Wall box: Single gang
Rated for: 125 volts

Built for upside down outlets

Look at the wall receptacle first. If the round ground pin sits over the two flat slots, this plate is matched to it. It sits flat over the face plate without altering the wall box.

Replaces the television lead

The line runs up to a non polarized connector shaped like a flat figure eight with two rounded lobes. It pushes straight into the back of the set, taking the place of the factory power cord.

Three outlets at the bottom

The five foot run drops down to an attached strip. You gain three places to plug in media boxes, audio components or consoles beneath the screen instead of crowding the original wall plate.

Removable clips in the box

The thin cord hugs the wall using adhesive strips and snap clips we pack with the unit. Press them against clean paint to route the line straight down the drywall to the floor.

$21.955-Foot Non-Polarized C7 TV Cord Kit for Inverted Outlets

Cut the same way